Loading ...
Loading ...
Loading ...
37
USER MAINTENANCE INSTRUCTIONS
Removing the drain filter and filter plate
to clean
3 Twist the circular drain filter anti/counter-
clockwise and lift to remove. It is normal to
find some water under it.
4 Remove the drain filter mesh by pinching
one side only and pulling it off, as shown.
Note: Do not attempt to remove the drain
filter mesh by pinching two opposing sides
together as this may damage the drain
filter mesh.
5 Wash both parts of the drain filter in hot
soapy water and rinse thoroughly under
running water.
6 Carefully lift the filter plate out. Remove
any foreign material on either side, wash
in hot soapy water and rinse thoroughly in
clean water, then wipe with a damp cloth.
Replacing the filter plate and drain filter
7 Carefully replace the filter plate. Ensure it
is fully pushed into position.
8 Refit the circular drain filter:
a) Push the drain filter mesh back onto the
holder. It should click into place.
b) Rotate the drain filter mesh until the
arrow on the mesh filter lines up with the
arrow on the holder.
c) Refit the drain filter into the drain hole
by lining up the arrow on the top of the
drain filter with the arrow on the filter
plate.
d) Rotate the drain filter clock wise until
the arrow on the drain filter lines up with
the arrow on the base of the drawer.
9 Either replace the whole base rack (if
removed) and/or replace the fixed tine
rack. Ensure the rack is replaced correctly
(the rear of the rack sits underneath the
anchoring loop and the right side rail of
the fixed tine rack sits inside the stop as
shown on previous page).
!0 Fold down the trap door
so it is resting on the
fixed tine rack and
replace the cutlery basket.
Drain filter
Drain filter mesh
Holder
After cleaning the
mesh, push back on.
Rotate the mesh anti-
clockwise until the
arrows line up as shown.
Pinch one side and
pull off mesh.
Filter plate
Line up the arrows on the filter
plate and insert the drain filter
Rotate the drain filter clockwise
until these arrows line up as shown
Loading ...
Loading ...
Loading ...