Loading ...
Loading ...
Loading ...
Installation Instructions
STEP 12 CONNECT WATER SUPPLY
&RQQHFWZDWHUVXSSO\OLQHWRHOERZ
• Slide compression nut, then ferrule over end of water line.
• Insert water line into
HOERZ
• Slide ferrule against
elbow and secure with
compression nut.
Figure BB
Figure CC
STEP 13 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
7KHPROGHGHQGRIWKHGUDLQKRVHZLOOILWWKURXJK
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port
&XWGUDLQKRVHFRQQHFWRURQWKHPDUNHGOLQHLIUHTXLUHG
WR¿WWKHLQOHWSRUW
,IDORQJHUGUDLQKRVHLVUHTXLUHGDGGXSWRRIOHQJWK
IRUDWRWDORIWRWKHIDFWRU\LQVWDOOHGKRVH8VHRU
LQVLGHGLDPHWHUKRVHDQGDFRXSOHUWR
connect the two
hose ends.
Secure the
connection with
hose clamps.
Figure DD
• Secure the drain hose to the air gap, waste tee or disposer
with clamps.
Note:727$/'5$,1+26(/(1*7+0867127(;&(('
)253523(5'5$,123(5$7,21
:DVWH7HH,QVWDOODWLRQ
Figure EE
Disposer Installation
:DVWH7HH,QVWDOODWLRQ
Figure FF
Disposer Installation
Method 2 – Drain Hose Routing
5RXWHWKHGUDLQKRVHRIWKHGLVKZDVKHUWRDPLQLPXPKHLJKWRI
IURPWKHÀRRUZLWKWKHVXSSOLHGKDQJHUDVVKRZQ
IMPORTANT±:KHQFRQQHFWLQJ
drain line to disposer, check to be sure
that drain plug has been removed.
',6+:$6+(5:,//127'5$,1,)
3/8*,6/()7,13/$&(
Tip: Avoid unnecessary service call charges. Always
be sure disposer drain plug has been removed before
attaching dishwasher drain hose to the disposer.
AT\^eT
7^__Ta
?[dV
7^bT2[P\_
2^d_[Ta
7^bT2[P\_
18"
Min.
32"
Min.
ggpp
IMPORTANT – Either one of the above methods must be
used or dishwasher will not operate properly.
Method 1 – Air gap with waste tee or disposer
Insert the drain hose to air gap as shown.
32"
Min.
18"
Min.
ggpp
IMPORTANT±&KHFNWREHVXUHWKDWGRRUVSULQJGRHV
not rub or contact the fill hose or water supply line. Test
by opening and closing the door. Re-route the lines if a
rubbing noise or interference occurs.
DRAIN LINE INSTALLATION
&RQQHFWGUDLQOLQHWRDLUJDSZDVWHWHHRUGLVSRVHUXVLQJ
either previously determined method.
Ferrule
90° Elbow
Compression Nut
Hot Water
Supply Line
Cutting Lines
1"
3/4"
5/8"
IMPORTANT: Do not cut corrugated
portion of hose
Loading ...
Loading ...
Loading ...