DH8060P3 User Manual

Loading ...

When a continuous series of beeps sounds, all the lights turn off onthe control panel

and a number appears on the display, a fault hasoccurred. The dryer will automatically

enter this mode if a fault occurs. The word ‘Fault’ will be shown in the control panel

display followed by a number. To stop the beeps, touch any button then perform the

following steps:

1 Turn your machine off at the power point.

2 Wait one minute and turn it back on.

3 Check your machine is installed correctly (refer to ‘Installation instructions’ section).

4 Remove your load from the dryer and retry.

5 Perform a ‘Time Dry’ cycle, eg Time Dry for 30 minutes.

6 If the fault re-occurs repeat steps

and

7 If the machine still will not work call a Fisher & Paykel trained and supported

servicetechnician to arrange service (refer to ‘Customer care’ section).

Recordthefaultcode number displayed and the serial number of your dryer

(locatedonthe rear of the machine, or on the insideof the door below the glass)

beforecalling. The fault code will indicateto the service technician what the

problemcould potentially be.

If a fault code is being displayed, you can still turn your dryer off by pressing

‘POWER’ .

FAULT CODES

Loading ...

User Manual - Page 28