DH8060P3 User Manual

Loading ...

Cleaning the condenser filter and evaporator grid

To maintain optimum performance of your dryer the condenser filter andevaporator

grid must be cleaned. The condenser filter and lint filter lights will flash when the

condenser filter requires cleaning, then turn off once you touch to start your cycle.

The condenser filter is located below the door on the left-hand side.

The evaporator grid is located behind the condenser filter.

To clean the condenser filter:

1 Switch off the power supply and remove

thepower plug.

2 Open the condenser filter cover.

3 Turn the four condenser lock levers 90°

thenpull out the condenser filter.

4 Remove rear filter and wipe the surface

cleanwith your hand.

To clean the evaporator grid:

5 With the condenser filter removed you will

be able to see the evaporator grid. Ifthesurface

of the evaporator grid is dirty, clean it carefully

with avacuum cleaner using a dusting brush or

anarrow crevice nozzle.

Begentle and do not bend the finemetalfins.

Cut Hazard. The surface of the evaporator has

sharp edges and contact may result in injury.

Handle with care when cleaning the grid

andalways keep blades away from fingers

andbody.

6 Replace the condenser filter.

7 Turn the four condenser filter lock levers to

lock the condenser filter back inplace again.

Make sure that these locksare engaged securely.

8 Close the condenser filter cover.

CARING FOR YOUR DRYER

Turning the condenser

filter locking levers

Pulling out the

condenser filter

Loading ...

User Manual - Page 25