Loading ...
Loading ...
Loading ...
16
ADJUSTMENT INSTRUCTIONS
7. Miter-Angle Indicator Adjustment
a. Remove the battery from the tool.
b. Square the blade to the fence, to make sure
that the blade is 90° to the fence and the miter-
detent locking system is engaged. Press the
miter-control lever (P) to lock the miter angle.
c. Loosen the miter-angle indicator screw and
adjust the miter-angle indicator (N) to the “0”
mark on the miter scale (M).
d. Tighten the miter-angle indicator screw.
8. Squaring the Blade to the Table
a. Remove the battery pack from the tool.
b. Lower the saw arm all the way and hold it down
while pushing the arm-lock pin (AC) to lock the
saw arm in the “DOWN” position.
c. Set the bevel and miter angles to 0°.
d. Place a combination square on the miter table
(L) with the rule against the table and the heel
of the square against the saw blade (O).
NOTE: Be sure to rest the square against the body
of the blade, and not against the teeth of the blade.
e. If the blade is not 90° to the table, loosen the
bevel-lock knob to unlock the bevel.
f. With a 3mm hex wrench (not included), adjust
the inner screw in or out until the leg of the
square is ush with the saw blade.
g. Once the angle is set, retighten the bevel-lock
knob. Recheck the blade-to-table alignment.
8a
7
M N
P
screw
8b
inner screw
O
L
Loading ...
Loading ...
Loading ...