Loading ...
Loading ...
Loading ...
©
2015 DJI. All Rights Reserved.
63
Appendix
INSPIRE 1
User Manual
FCC Compliance
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modications not expressly roved by the party responsible for compliance could void the
user's authority to operate the equipment.
b. Extract all downloaded les into the root directory of an SD card or USB ash drive.
c. Turn off the remote controller, Insert the SD card into a SD card reader or the USB disk onto the
remote controller USB port when remote controller is turned off.
d. Power on the remote controller and wait 60 seconds until the upgrade begins. Do not power off
the remote controller during the update.
e. It will take approximately 10 minutes to complete the rmware update. The camera will sound
a beeping sound and the Status LED on the remote controller shows solid blue to indicate the
update is in progress. The Status LED on remote controller shows solid green and beeping
sound will stop if the upgrade is completed with success.
f . If you do not have a SD card reader, you may insert the SD card into the gimbal and connect the
gimbal with remote controller to upgrade the remote controller.
You will only be able to update the remote controller rmware through the DJI GO app from
this point onwards.
Updating Intelligent Flight Battery Firmware
The Intelligent Flight Battery is upgraded during the aircraft rmware upgrade process. It is recommended
to keep the upgrade package files in your SD card. The upgrade will start automatically after power
cycling the aircraft.
Ensure there is only one rmware package le stored on your SD card.
Only storage devices that are formatted for FAT32 and exFAT le systems are supported for
aircraft and remote controller rmware updates.
Ensure the internet connection of your mobile device is stable when downloading the rmware
update package.
Turn on Airplane Mode on your mobile device before updating the rmware, as any incoming
calls may disrupt the update process.
Do not perform rmware update while the aircraft is still ying in the air. Only carry out rmware
update when the aircraft is landed.
Be sure to update the remote controller’s rmware to the latest version after you upgrade the
aircraft’s rmware.
The remote controller may become unlinked from the aircraft after updating. Re-link the remote
controller and aircraft.
Conrm the update results based on the blinking pattern of camera status indicator or gimbal
sound. It is normal for the aircraft to sound or the LED to blink during the update process.
Loading ...
Loading ...
Loading ...