Loading ...
Loading ...
Loading ...
16
©
2015 DJI. All Rights Reserved.
Aircraft
INSPIRE 1
User Manual
20m
20m
H
If the aircraft is ying under 20 meters (65 feet) and Failsafe (including
Smart RTH, Lower Battery RTH ) is triggered, the aircraft will first
automatically ascend to 20 meters (65 feet) from the current altitude.
You can only cancel the ascending by exiting the Failsafe. Refer to “RTH
Button” on page 29 for more information on how to exit the Failsafe and
regain the control of the remote controller.
20m
20m
H
Aircraft automatically descends and lands if RTH is triggered when the
aircraft ies within a 20 meters (65 feet) radius of the Home Point. Aircraft
will stop ascending and immediately return to the Home Point if you move
the throttle stick if the aircraft reaches 20 meters (65 feet) altitudes or
beyond during Failsafe.
20米
20米
H
Aircraft cannot return to the Home Point when GPS signal is weak
( [
] displays grey) or unavailable.
20米
20米
H
if you move the throttle stick after the aircraft rises above 65 feet
(20m) but below the pre-set Failsafe RTH altitude, the aircraft will stop
ascending and immediately return to the Home Point.
Dynamic Home Point
Dynamic home point is useful in situations when you are in
motion and require a Home Point that is different from the
takeoff point. GPS module is located at the position shown in
the gure below:
Ensure the space above the GPS module is not
obstructed when using Dynamic Home Point.
GPS
There are two options for Dynamic Home Point.
1. Set the aircraft current coordinate as the new Home Point.
2. Set the remote controller’s coordinate as the new Home Point.
Setting Up Dynamic Home Point
Follow the steps below to setup Dynamic Home Point:
1. Connect to the mobile device and launch the DJI GO app and go to the “Camera” page.
2. Tap“
”and select“ ”, to reset the remote controller’s coordinates as the new Home Point.
3. Tap“
”and select“ ”, to reset the
aircraft
’s coordinates as the new Home Point.
4. The aircraft status indicator blinks green to show Home Point is set successfully.
Loading ...
Loading ...
Loading ...