Loading ...
Loading ...
Loading ...
34
©
2015 DJI. All Rights Reserved.
Remote Controllers
INSPIRE 1
User Manual
RC Control Setting
Remote Control Calibration
Stick Mode
Gimbal Pitch/YawC1 C2 Reset gimbal yaw
Default stick mode is Mode 2, changing stick modes alters the way the aircraft is controlled.
Do not change unless familiar with your new mode.
You can customize the C1 and C2 buttons on the back
of the remote controller.
Linking Remote Controller
C2
Searching for aircraft frequency,
timeout in 54 seconds
Cancel
Press the linking button on the aircraft
to link this remote controller
Remote controller cannot link to the aircraft if the remote controller is set as “Slave”. Meanwhile,
the “Slave” remote controller cannot control the orientation of the aircraft. Reset the remote
controller to “Master” in DJI GO app if you wish to link the remote controller to the aircraft.
Remote controller will disconnect from the linked aircraft if a new remote controller is linked to
the same aircraft.
Remote Controller Compliance Version
The remote controller is compliant with both CE and FCC requirements.
5. Locate the Linking button on the front of the aircraft, as shown in the gure shown below. Press the
Linking button to start linking. The Remote Controller Status Indicator will display solid green if Link is
succeed.
4. The remote controller is ready to link. The Remote Controller Status Indicator blinks blue and "beep"
sound is emitted.
Loading ...
Loading ...
Loading ...