Loading ...
Loading ...
Loading ...
26
©
2018 DJI All Rights Reserved.
Mavic Air
User Manual
12
61%
2.4G
12
09:29
ISO
SHUTTER
EV
WB
1600 0.31/8000
CAPACITY
1080P/2420GB
GO
TapFly
In flight (GPS)
Forward
Reverse CoordinateFree
Exiting TapFly
Press the Flight Pause button on the remote controller or pull a control stick in the direction opposite to
the direction of ight and the aircraft will brake and hover in place. Tap the screen to resume TapFly. Tap
or toggle the Flight Mode switch to S-mode to exit TapFly.
DO NOT use TapFly in areas with people, animals, small or ne objects (e.g. tree branches or
power lines), or transparent objects (e.g. glass or water). TapFly Mode may not work properly
when the aircraft is ying over water or snow covered areas.
There may be deviations between expected and actual ight paths selected in TapFly.
The selectable range for the target direction is limited. You cannot make a selection close to
the upper or lower edges of the screen.
1 m
TapFly
TapFly features four sub-modes, Forward, Backward, Free, and Coordinate. Provided that lighting conditions
are suitable (between 300 and 10,000 lux), the aircraft will automatically avoid obstacles it senses.
Forward: The aircraft will y towards the target with the Forward Vision System sensing obstacles.
Backward: The aircraft will y in the opposite direction of the target with the Backward Vision System
sensing obstacles..
Free: The aircraft will y towards the target. The remote controller can be used to maneuver the
orientation of the aircraft freely.
Coordinate: Tap a specic location on screen. The aircraft will travel to that point at its current altitude,
then hover in place.
Using TapFly
Ensure that the aircraft is in P-mode and that the Intelligent Flight
Battery is sufficiently charged. Follow the steps below to use
TapFly:
1. Take o and hover at least 3.3 ft (1 m) above the ground.
2. In DJI GO 4, tap , select TapFly, then select a sub-mode and follow the prompts.
3. Tap once on the target and wait for the “GO” button to appear. Tap the “GO” button to conrm the
selection and the aircraft will y to the target automatically. A prompt will appear if the target cannot
be reached. If this is the case, select another target and try again. The target can be changed mid-
ight by tapping the screen.
Loading ...
Loading ...
Loading ...