Loading ...
Loading ...
Loading ...
8.914-458.0-G • Water Maze CLB-603
OPERATOR’S MANUAL WATER TREATMENT SYSTEM
34
Lamp replacements are available from your Water
Maze Dealer should they need to be replaced. Simply
turn off the power to the CLB at the breaker, remove
the screws on the power pack cover and remove the
cover. Disconnect the plug on the end of the ozone
lamp. Now, loosen the lamp holder locking ring from
around the end of the lamp by turning it counterclock-
wise and remove it. Remove the lamp by grabbing
the rubber bushing around the end of the lamp and
pulling it straight out. Remove the rubber bushing from
the lamp and install it on your new lamp, making sure
the outer edge of the bushing is fl ush with the outer
edge of the silver end cap on the lamp. Now, slide the
lamp back into the reaction chamber. The lamp holder
may now be reinstalled and tightened. Reinstall the
plug onto the lamp and replace the power pack cover.
CAUTION: Keep the lamp free of fi ngerprints and
dust particles by only handling the metal end caps
on the lamp. You can clean the lamp with rubbing
alcohol and a soft cloth. A dirty lamp will not allow
maximum ozone output.
ULTRAVIOLET LIGHT
COMPLIANCE
Ultraviolet Light Safety Requirements
The device used in this product is a Class 1 certifi ed
ozone generator product. Operating this product outside
specifi cations or altering its original design may result
in hazardous radiation exposure, and may be consid-
ered an act of modifying or new manufacturing of a laser
product under U.S. regulations contained in 21CFR
Chapter 1, subchapter J.
CAUTION: Avoid exposure to direct or
strongly refl ected germicidal ultraviolet
rays.
DO NOT STARE INTO BEAM.
ATTENTION: Éviter l'exposition aux rayons
ultraviolets germicides fortement réfl échis.
NE PAS REGARDER DIRECTEMENT LE FAIS-
CEAU.
DANGER: Ultraviolet radiation. Disconnect
Power Before Replacing Lamp.
ATTENTION: Radiation ultraviolette. Débrancher
l'alimentation avant de remplacer la lampe.
DANGER: Connect only to a circuit that is pro-
tected by Ground Fault Circuit Interrupt (GFCI).
DANGER: Raccorder uniquement à un circuit qui
est protégé par un disjoncteur différentiel de
fuite à la terre (DDFT).
Instructions for Disposing of Your UV
Light Tube
1. Do not break a UV light tube. Keep all tubes whole
if possible. If a UV light tube is accidentally broken,
wear gloves while picking up the pieces, and care-
fully dispose of them in a trash bag. Wipe the area
with a wet wipe, and put the wet wipe in the same
trash bag. Place the trash bag with broken pieces
inside another trash bag. Mark the bag with a sign
labeled, "Broken Mercury Light Bulb".
2. Remove the UV light tube from the Ozone Genera-
tor. Place the used tube in the trash bag, and place
that bag inside another trash bag. Seal the openings
and then tape a slip of paper on the outer bag labeled,
"Mercury LIght Bulb."
3. Take the used and /or broken mercury tube to your
nearest recycling bin for mercury light bulbs or take
this tube to a state-approved recycling center.
SPECIFICATIONS:
Energy Required 220V: 210VAC MIN., 230V MAX.,
.450AMP/Ballast
Power Consumption: 20 Watts
Average Lamp Life: 9,000 Hours
CENTRIFUGAL PUMP
Your centrifugal pump has been quality-built and engi-
neered to give you effi cient, dependable service. It is
equipped with union connectors to make installation
and future service easier.
The advanced design uses a single speed motor
which reduces operation and maintenance to simple,
common-sense procedures.
PUMP OPERATION
(Ozone, Infeed, or Transfer)
WARNING: Do not touch
pumps, pump motors, water
or discharge piping when the
pumps are connected to elec-
trical power. Do not handle a
pump or pump motor with wet
hands or when standing on a
wet or damp surface or in water.
WARNING
RISK OF ELECTRIC
SHOCK: USE CAUTION
WHEN HANDLING.
OZONE GENERATOR
Loading ...
Loading ...
Loading ...