Loading ...
Loading ...
Loading ...
56
• Wipe down all areas in the sweat path with a damp cloth after each
use to prevent rust.
• Check hand grips, seat cushions and foot pedals for signs of wear
(once a month).
• If a squeak, thump, clicking or rough feeling develops the main
cause is most likely one of two reasons:
- The hardware was not suciently tightened during assembly. All
bolts that were installed during assembly need to be tightened as
much as possible. It may be necessary to use a larger wrench than
the one provided if you cannot tighten the bolts suciently. I
cannot stress this point enough; 90% of calls to the service
department for noise issues can be attributed to hardware not
being tightened enough.
• If squeaks or other noises persist, check that the unit is properly
leveled. See page 15 for leveling instructions.
Maintenance menu in console software
The console has built in maintenance/diagnostic software. The software
will allow you to change the console settings from English to Metric and
turn o the beeping of the speaker when a key is pressed for example. To
enter the Maintenance menu (may be called Engineering mode,
depending on version) press and hold down the Start, Stop and Enter
keys. Keep holding the keys down for about 5 seconds and the message
window will display “Engineering mode”. Press the enter button to access
the menu below:
Maintenance
Loading ...
Loading ...
Loading ...