Loading ...
Loading ...
Loading ...
34
3
Select the play mode.
STEREO
(Main unit) (Remote control unit)
Example: Stereo
4
Start playback on the selected component.
• For operating instructions, refer to the component’s
manual.
5
Adjust the volume.
MASTER VOLUME
(Main unit) (Remote control unit)The volume level is
displayed on the
master volume level
display.
The volume can be adjusted within the range of –70 to 0 to 18 dB,
in steps of 1 dB. However, when the channel level is set as
described on page 25 or page 42, if the volume for any channel is
set at +1 dB or greater, the volume cannot be adjusted up to 18
dB. (In this case the maximum volume adjustment range is “18 dB
— (Maximum value of channel level)”.)
Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in the
“ANALOG” or “PCM” mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to “AUTO” or “DTS”.
Input mode display
ANALOG
ANALOG
AUTO
PCM
DTS
INPUT MODE
AUTO
PCM
DTS
INPUT MODE
AUTO
PCM
DTS
INPUT MODE
AUTO
PCM
DTS
INPUT MODE
• In the AUTO mode
• In the PCM mode
• In the DTS mode
• In the ANALOG mode
Input signal display
PRO LOGIC
DIGITAL
SIGNAL
PURE
DIRECT
PURE
DIRECT
DIGITAL
SIGNAL
DIGITAL
DIGITAL
• DOLBY DIGITAL
• DTS
One of these lights, depending on the
input signal.
After starting playback
[1] Adjusting the sound quality (tone)
The tone control function will not work in the DIRECT, PURE DIRECT and Home THX Cinema mode.
1
The tone switches as follows each time the
TONE CONTROL button is pressed.
2
With the name of the volume to be
adjusted selected, turn the SELECT
knob to adjust the level.
TONE
CONTROL
SELECT
2 13
BASS
TREBLE
(Main unit)
(Main unit)
• To increase the bass or treble: Turn the control clockwise.
(The bass or treble sound can be increased to up to +12 dB
in steps of 2 dB.)
• To decrease the bass or treble: Turn the control clockwise.
(The bass or treble sound can be decreased to up to –12 dB
in steps of 2 dB.)
The indicator lights when digital signals are being input
properly. If the indicator does not light, check whether
the digital input component setup (page 29) and connections are
correct and whether the component’s power is turned on.
DIGITAL
DIGITAL
NOTE:
• The indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will be
heard.
DIGITAL
Loading ...
Loading ...
Loading ...