Loading ...
Loading ...
Loading ...
EN 20
CONVERSION INSTRUCTION
3A. Screw the by-pass screws (3) of all gas taps completely in by using
the flat-blade screwdriver (T2).
3B. Remove the by-pass screws by using the flat-blade screwdriver (T2)
and the nose pliers (T3). Place the new by-pass screws with the
nose pliers and screw the by-pass screws of all gas taps completely
in, by using the flat-blade screwdriver.
3C. Adjust the by-pass screws (3) of all gas taps by using the
flat-blade screwdriver (T2) until a stable flame is established
with a minimal gas flow. Please check if the flame is stable in
cold and hot condition of the burner.
B2
B1
T2+T3
T2+T3
3
Check for gas tightness and operation
When the appliance is connected to the gas supply, use leak test spray
to check the gas tightness:
1. Seal the injector.
2. Open the gas tap.
Attention: press and open tap to override the thermo-electric safety
device and keep it pressed down.
3. Spray leak test spray over all gas connections and check for gas
tightness.
4. Repeat for every burner.
Loading ...
Loading ...
Loading ...