Loading ...
Loading ...
Loading ...
EN 19
CONVERSION INSTRUCTION
Converting nozzles
Please note: disconnect the appliance from the power supply.
Prevent damage of the worktop. Lay down parts of the appliance on
a protected base.
For converting to a different type of gas, the nozzles have to be
changed. The values are also marked on the nozzle.
1. Remove pan supports, burner heads, crowns and covers (see
pictures A1 and A2). Pull off the control knobs vertically.
2. Use the socket (T1) or open end spanner (T4) to remove the old
nozzles and place the new nozzles inside the burner cups (see
pictures A1 and A2).
A1
A2
1
2
T1
T4
Converting by-pass screws
Depending on the gas type to which the appliances will be converted,
there are two ways to adjust the by-pass screws.
Please check the conversion table in the column “Modification” if the
by-pass screws have to be screwed completely in (see action 3A below),
replaced by a different by-pass screw (see action 3B below) or adjusted
(see action 3C below).
The values are also indicated on the top of the by-pass screws.
The by-pass screws can be reached from the top of the hob when the
knobs are removed (B2).
Loading ...
Loading ...
Loading ...