Loading ...
Loading ...
Loading ...
33
• Wipe down all areas in the sweat path with a damp cloth after each
use to prevent rust.
• If a squeak, thump, clicking or rough feeling develops the main
cause is most likely one of two reasons:
- The hardware was not suciently tightened during assembly. All
bolts that were installed during assembly need to be tightened as
much as possible. It may be necessary to use a larger wrench than
the one provided if you cannot tighten the bolts suciently.
I cannot stress this point enough; 90% of calls to the service
department for noise issues can be traced to loose hardware.
- The crank arm nut and/or the pedals need to be retightened.
• If squeaks or other noises persist, check that the unit is properly
leveled. There are 2 leveling pads on the front and 2 leveling pads
on the back of the unit. Remove mast cover and center cover.
Step rail and carriage maintenance
Dirt and dust can accumulate on the pedal carriage components causing
a rough feel which means the rails and wheels most likely need cleaning.
• Remove mast cover and center cover.
• Firmly press in at the bottom of the small mast cover at the front
and rear and pull up
- Firmly press in at the top of the main cover near the top and pull
up on the center cover. Repeat this process at all four corners of
the cover.
- Slide the mast and center covers up the mast tube. Tie a rag
around the tube and let the covers rest on it so they stay in place.
• Move the pedals so one is all the way forward. Clean the wheels and
rails using a rag and alcohol.
• Replace the covers when done.
Maintenance
Loading ...
Loading ...
Loading ...