Loading ...
Loading ...
Loading ...
How Your Dishwasher Cleans
Your dishwasher cleans by spraying a
mixture of hot water and detergent through
the spray arms against soiled surfaces.
The dishwasher fills with water covering the
filter area. Water is then pumped through
the multiple filter and spray arms. Soiled
water goes down the drain as the water is
pumped out and replaced with clean water.
The number of water fills will vary with the
cycle being used.
Getting Started
1. Load dishwasher.
2. Add detergent.
3. Add rinse aid, if needed.
4. Close door latch.
5. Select desired CYCLE. The indicator light
above the touchpad will glow when
selected.
6. Select desired OPTIONS. The indicator
light above the touchpad will glow when
selected.
7. Run the hot water faucet nearest the
dishwasher until the water is hot. Turn
the water off afterwards.
8. To start, press START/CANCEL on
the touchpad.
NOTE: Selections will only be
activated when the door is firmly
closed.
NOTE: The dishwasher is programmed to
remember your last cycle so you do not
have to reset each time. To start the
dishwasher using the same cycle and
options selected on the previous wash, just
press START/CANCEL on the touchpad.
Wash Cycle Selections
Cycle times are approximate and will vary
with options. Hot water is necessary to
activate dishwasher detergent and clean
fatty food particles. An automatic sensor
will check the incoming water temperature
and if it is not hot, the timer will be delayed
for automatic water heating in the main
wash of all cycles. This happens even
when HI-TEMP WASH is selected and a
higher temperature is guaranteed to
handle heavier food particles.
Page 4
Loading ...
Loading ...
Loading ...