Loading ...
Loading ...
Loading ...
Cable direct connections may pass through the same hole as the drain hose and hot
water line, but power cords with plugs must pass through a separate hole.
Preparing the Hot Water Line
- The water connection is on the left side of dishwasher.
- The hot water line may enter the opening from either side, the rear, or the floor within
the shaded area.
- The hot water line may pass through the same hole as the electrical and drain hose.
Or, you can drill an additional 1-1/2 in. maximum diameter hole for the hot water line.
- If a power cord with a plug is used, the hot water line may not pass through
the same hole as the power cord.
Connecting the Water Line to the
Water Supply
NOTE: The hot water pressure must be
between 20 and 120 psi.
1. Turn off the water supply
2. Install a hand shut-off valve in an
accessible location, such as under the sink.
This is optional, but strongly recommended,
and may be required by local codes.
3. Install the hot water inlet line, using at
least 3/8 in. O.D. copper tubing. Route the
line as shown in the figure above and
extend it forward at least 18 in. from the rear
wall of the enclosure.
4. Adjust the water heater to a temperature
of from 120° F to 150° F.
5. Flush the water line to clean out any
debris.
Page 11
Loading ...
Loading ...
Loading ...