Loading ...
Loading ...
Loading ...
41
Operation
Remote Control
Your remote control has been programmed at the factory to operate with your garage door
opener.
Up to 24 Security+ 2.0 remote controls can be programmed to the garage door opener. Older
LiftMaster remote controls are NOTcompatible, see page 46 for compatible accessories. To program
additional accessories refer to the instructions provided with the accessory or visit LiftMaster.com. If
your vehicle is equipped with a Homelink
®
, you may require an external adapter depending on the
make, model, and year of your vehicle. Visit www.homelink.com for additional information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN USING
THE DOOR CONTROL
1.
Press the LEARN button on the door control twice. The Command LED will blink.
2.
Remote Control:Press and release the button on the remote control that you wish to operate
your garage door.
Keyless Entry: Enter a 4-digit personal identification number (PIN) on the keypad. Then
press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) and the Command LED will stop
blinking when the code has been programmed. Repeat the steps above for programming additional
remote controls or keyless entry devices. If programming is unsuccessful, program the remote using
the learn button.
LEARN button
Command LED
Mulrti-Function Door Control Motion Detecting Control Panel
1
OR
OR
PIN
? ? ? ?
4
GHI
5
JKL
7
PRS
8
TUV
9
WXY
0
QZ
*
#
ENTER
0
QZ
*
#
ENTER
6
MNO
2
LEARN button
Command LED
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL USING THE LEARN BUTTON
1. Press and release the LEARN Button on the garage door opener.
2. Press and hold the button on the remote control that you wish to use. Release the button
when the garage door opener lights blink or two clicks are heard.
“click”
“click”
1
2
LEARN LED
LEARN
Button
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the LEARN button on garage door opener until the learn LED goes out
(approximately 6 seconds). All remote control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES (INCLUDING myQ
®
ENABLED ACCESSORIES)
1. Press and hold the LEARN button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2. Immediately press and hold the LEARN button again until the learn LED goes out. All codes
are now erased. Reprogram any accessory you wish to use.
ERASE THE Wi-Fi NETWORK FROM THE GARAGE DOOR OPENER
1. Press and hold the black adjustment button on the garage door opener until 3 beeps are
heard (Approximately 6 seconds).
LEARN Button
Black Adjustment Button
Loading ...
Loading ...
Loading ...