Loading ...
Loading ...
Loading ...
39
Operation
Using the Motion Detecting Control Panel
SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, press the push bar until the garage
door opener activates (it may take up to 3 presses). Test the door control by pressing the push bar,
each press of the push bar will activate the garage door opener.
Up to 2 Smart Control Panels
®
or 4 of any other Security+ 2.0
®
door controls can be connected to
the garage door opener.
Push Bar
LIGHT Button
SERVICE LED
LOCK Button
COMMAND LED
LEARN Button
LIGHT Button
PUSH BAR
Press the push bar to open or close the door.
LIGHT BUTTON
Press the LIGHT button to turn the garage door opener lights on or off. When the lights are turned on
they will stay on until the LIGHT button is pressed again, or until the garage door opener is activated.
Once the garage door opener is activated the lights will turn off after the specified period of time (the
factory setting is 4-1/2 minutes). The LIGHT button will not control the lights when the door is in
motion.
The following features are accessible by lifting up the push bar:
LEARN A DEVICE
Any compatible remote controls, wireless keyless entry, Wi-Fi garage door openers, ormyQ
®
accessories can be programmed to the garage door opener by pressing the LEARN button on the
Motion-Detecting Control Panel, see page 41.
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from remote controls
while still allowing activation from the door control and keyless entry. This feature is useful for added
peace of mind when the home is empty (i.e. vacation).
AUTOMATIC LIGHT
Motion Sensor (Premium Motion-Detecting Control Panel)
Factory default is set to on. This feature automatically turns on the garage door opener lights when
motion is sensed. The lights will come on for the set period of time, then shut off. If using the garage
door opener light as a work light disable the motion sensor, otherwise the light will turn off
automatically if you are beyond the range of the sensor.
Light Feature
The lights will turn on when someone enters through the open garage door and the safety reversing
sensor infrared beam is broken.
MAINTENANCE ALERT (MAS)
This feature assists the homeowner in ensuring the garage door opener system stays in good working
condition. When the garage door opener needs to be serviced (approximately 4500 garage door
opener cycles) the command (yellow) and service (red) LEDs will begin to alternately flash back and
forth. The factory setting for the MAS feature is off and can be activated at time of installation. Contact
your installing dealer for service.
Loading ...
Loading ...
Loading ...