8355W User Manual

Loading ...

Install the Door Control

1 Install the Door Control

To prevent possible SERIOUS INJURY or DEATH from electrocution:

• Be sure power is NOT connected BEFORE installing door control.

• Connect door control ONLY to 12 VOLT low voltage wires.

To prevent possible SERIOUS INJURY or DEATH from a closing garage door:

• Install door control within sight of garage door, out of reach of small children at a

minimum height of 5feet (1.5m) above floors, landings, steps or any other adjacent

walking surface, and away from ALL moving parts of door.

• NEVER permit children to operate or play with door control push buttons or remote

control transmitters.

• Activate door ONLY when it can be seen clearly, is properly adjusted, and there are no

obstructions to door travel.

• ALWAYS keep garage door in sight until completely closed. NEVER permit anyone to

cross path of closing garage door.

INTRODUCTION

Compatible with myQ

and Security+ 2.0 accessories, see page 46. Your garage door opener is

compatible with up to 2 Smart Control Panels or 4 of any other Security+ 2.0 door controls.

NOTE:Older LiftMaster door controls and third party products are not compatible.

Install door control within sight of garage door, out of reach of small children at a minimum height of

5feet (1.5m) above floors, landings, steps or any other adjacent walking surface, and away from ALL

moving parts of door. For gang box installations it is not necessary to drill holes or install the drywall

anchors. Use the existing holes in the gang box.

NOTE: Your product may look different than the illustrations.

HARDWARE

Screw

6AB x 1" (2)

Drywall

Anchors (2)

Screw

6-32 x 1" (2)

1. Strip 7/16" (11 mm) of insulation from one end of the wire and separate the wires.

2. Connect one wire to each of the two screws on the back of the door control. The wires can be

connected to either screw.

PRE-WIREDINSTALLATIONS:Choose any two wires to connect, note which wires are used

so the correct wires are connected at the garage door opener in a later step.

3. Mark the location of the bottom mounting hole and drill a 5/32" hole.

4. Install the bottom screw, allowing 1/8" (3 mm) to protrude from the wall.

5. Position the bottom hole of the door control over the screw and slide down into place.

6. Lift the push bar up and mark the top hole.

7. Remove the door control from the wall and drill a 5/32" hole for the top screw.

8. Position the bottom hole of the door control over the screw and slide down into place. Attach

the top screw.

7/16" (11 mm)

Wall

2 3

DRYWALL

GANG BOX

6AB x 1"

6-32 x 1"

Drywall Anchor

4-5