Loading ...
Loading ...
Loading ...
Transmission Oil
(1)
(2)
(3)
(1)
(3)
(2)
(1) transmission oil fill cap
(2) transmission oil drain bolt
(3) sealing washer
Servicing Your Honda 47
Checking & Adding Oil
(1) transmission oil fill cap (3) sealing washer
(2) oil check bolt
1. Run the engine at idle for 3 minutes, then shut
it off.
2. Wait 3 minutes after shutting off the engine to
allow the oil to properly distribute itself in the
clutch and transmission.
3. Support the CRF in an upright position on a
level surface.
4. Remove the transmission oil fill cap (1), oil
check bolt (2) and sealing washer (3) from the
right crankcase cover. A small amount of oil
should flow out of the oil check bolt hole.
Allow any excess oil to flow out of the oil
check bolt hole.
If no oil flows out of the oil check bolt hole,
add oil slowly through the transmission oil fill
hole until oil start to flow out of the oil check
bolt hole.
Tighten the oil check bolt with a new sealing
washer and transmission oil fill cap. Repeat
step 1 4.
5. After inspection the oil level or adding oil,
tighten the oil check bolt to the specified
torque:
Oil Check Bolt:
9 lbf·ft (12 N·m, 1.2 kgf·m)
6. Check that the O-ring on the transmission oil
fill cap is in the good condition and replace it
if necessary.
7. Install the transmission oil fill cap securely.
Replacing Transmission Oil
1. Run the engine at idle for 3 minutes, then shut
it off.
2. Support the CRF in an upright position on a
level surface.
3. Remove the transmission oil fill cap (1) from
the right crankcase cover.
4. Place an oil drain pan under the engine to
catch the oil. Then remove the transmission
oil drain bolt (2) and sealing washer (3).
5. After the oil has drained, apply engine oil to
the transmission oil drain bolt threads and
tighten it with a new sealing washer to the
specified torque:
12 lbf·ft (16 N·m, 1.6 kgf·m)
6. Fill the crankcase with recommended oil.
Capacity:
0.71 US qt (0.67R) draining
7. Check the transmission oil level by following
the steps in
Checking & Adding Oil (this
page).
Pour the drained oil into a suitable container and
dispose of it in an approved manner (page 143).
Improper disposal of drained fluids is harmful to
the environment.
NOTICE
Loading ...
Loading ...
Loading ...