Loading ...
Loading ...
Loading ...
22
TAIL END BEER
Beer draws well at the beginning of the barrel. Towards the end of the barrel the beer is flat. This
is more likely to occur when beer turnover is slow.
Causes Corrections
Where air is used as a pressure source, air
replaces the CO
2
in beer causing flat beer.
Where beer is being drawn rapidly this
problem is not so evident.
Wherever possible, CO
2
gas should be used as
pressure source.
GENERAL TROUBLESHOOTING
You can solve many common Beer Dispenser problems easily, saving you the cost of a possible service
call. Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
POSSIBLE CAUSE
Beer Dispenser does not operate.
Not plugged in.
Circuit breaker tripped or blown fuse.
The temperature control knob is set in “OFF”
position.
Turns on and off frequently.
The room temperature is hotter than normal.
The door is open too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The Beer Dispenser does not have the correct
clearances.
Vibrations
Check to be sure the Beer Dispenser is level.
The Beer Dispenser seems to make too much
noise.
The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your
Beer Dispenser.
Contraction and expansion of the inside walls
may cause popping and crackling noises.
The Beer Dispenser is not level.
The door will not close properly.
The Beer Dispenser is not level.
The door was reversed and not properly installed.
The gasket is dirty.
The shelves or metal plate or beer keg are out of
position.
Loading ...
Loading ...