Loading ...
Loading ...
Loading ...
7
PTAC
MOTION
SENSOR
OUTSIDE
PTAC
MOTION
SENSOR
OUTSIDE
Typical Room Layouts
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by on or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
CAUTION
This equipment is authorized for use under the
United States Federal Communication Commission
Rules and Regulations, Code of Federal Regulations
Chapter 47 part 15 and must be installed in accord-
ance with the instructions provided in this document.
Failure to install or operate this equipment as in-
structed in this document could void the user's auth-
ority to operate the equipment. This equipment con-
tains no user servicable parts. Any modification or
repairs to the internal components or to the antenna
configuration of the equipment without the express
written consent of Everex Communications, Inc.
could void the user's authority to operate the equip-
ment.
NOTE: To comply with FCC RF exposure requirements in section
1.1307, a minimum separation distance of 20cm (8 inches) is
required between the equipment and all persons.