Loading ...
Loading ...
Loading ...
23
The oven door must be closed and all controls set correctly for the cycle to work properly.
After a Clean Cycle
You may notice some white ash in the oven.
Wipe it up with a damp cloth after the
oven cools.
If white spots remain, remove them with
a soap-filled steel-wool pad and rinse
thoroughly with a vinegar and water mixture.
These deposits are usually a salt residue
that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
■ You cannot set the oven for cooking until
the oven is cool enough for the door
to unlock.
■ While the oven is self-cleaning, you can
touch the CLOCK pad to display the time
of day. To return to the clean countdown,
touch the COOK TIME pad.
■ If the racks become hard to slide,
apply a small amount of vegetable oil
or cooking oil to a paper towel and wipe
the edges of the oven racks with
the paper towel.
GEAppliances.ca
How to Delay the Start of Cleaning
You can set the oven control to delay-start
the oven, clean for a specific length of time
and then turn off automatically.
Make sure the clock shows the correct time
of day.
Follow the directions in the Before a Clean
Cycle section.
Latch the door.
NOTE: Never force the latch. If the oven is too
hot, you will not be able to slide the latch.
Allow the oven to cool.
Touch the CLEAN pad.
Touch the + or – pads to set
the Clean Time.
The Clean Time is preset for 4 hours and 20
minutes. You can change the Clean Time to
any time between 3 and 5 hours, depending
on the amount of soil in your oven. If a
different Clean Time is desired, touch the + or –
pads until the desired Clean Time is displayed.
Touch the START TIME pad.
Change the Start Time by touching the + or –
pads. The start time will appear in the display.
Touch the START/ON pad.
The self-clean cycle will automatically begin
at the time set.
While the oven is self-cleaning, you can
touch the CLOCK pad to display the time
of day. To return to the clean countdown,
touch the CLEAN pad.
The oven shuts off automatically when
the clean cycle is complete, and 0:00 will
flash in the display.
Slide the latch handle to the left as far as
it will go and open the door.
To Stop a Clean Cycle
Touch the OFF pad.
Wait until the oven has cooled below
the locking temperature to unlatch the door.
You will not be able to open the door right
away unless the oven has cooled below
the locking temperature.
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips
Consumer Support
Loading ...
Loading ...
Loading ...