User Manual - Page 35

For 2018 RENEGADE.

Loading ...
Loading ...
Loading ...
The Rain Sensing feature can be turned on
and off using the Uconnect System, refer to
“Uconnect Settings” in “Multimedia” in
your Owner’s Manual for further
information.
Rear Wiper Operation
The rear wiper/washer controls are located on
the lever on the right side of the steering
column. The rear wiper/washer is operated by
rotating a switch, located at the middle of the
lever.
NOTE:
If the front wiper is moving and the vehicle is
shifted in REVERSE, the rear wiper will per-
form one round up to clean the rear window.
Rotate the center portion of the lever upward
to the first detent for intermittent operation
and to the second detent for continuous rear
wiper operation. If the front wiper is set to
Automatic Mode (on the wiper stalk as well as
“Enabled” through Uconnect settings), plac-
ing the rear wiper in an intermittent position
will cause the front and rear wipers to sync
up. Turning the front wipers off will cause the
rear wipers to also stop.
To use the washer, push the lever forward and
hold while spray is desired. If the lever is
pushed while in the intermittent setting, the
wiper will turn on and operate for several wipe
cycles after the end of the lever is released,
and then resume the intermittent interval
previously selected.
If the lever is pushed while the wiper is in the
off position, the wiper will operate for several
wipe cycles, then turn off.
NOTE:
As a protective measure, the pump will stop if
the switch is held for more than 30 seconds.
Once the lever is released, the pump will
resume normal operation.
Rear Window Defroster
The rear window defroster button is located
with the Climate Controls on the instrument
panel. Push this button to turn on the rear
window defroster. An indicator in the button
will illuminate when the rear window de-
froster is on. The rear window defroster auto-
matically turns off after approximately
20 minutes. To manually shut the defroster
off, push the button a second time.
Auto Comfort Systems If Equipped
In vehicles equipped with Auto On Comfort,
when turning on the vehicle the driver’s
heated seat will automatically turn on when
temperatures are below 40° F (4.4° C).
Auto Comfort Systems can be enabled or
disabled. Refer to “Uconnect Settings” in
“Multimedia” in your Owner’s Manual for
further information.
CAUTION!
Failure to follow these cautions can cause
damage to the heating elements:
Use care when washing the inside of the
rear window. Do not use abrasive window
cleaners on the interior surface of the
window. Use a soft cloth and a mild
washing solution, wiping parallel to the
heating elements. Labels can be peeled
off after soaking with warm water.
Do not use scrapers, sharp instruments,
or abrasive window cleaners on the inte-
rior surface of the window.
Keep all objects a safe distance from the
window.
33
Loading ...
Loading ...
Loading ...