Loading ...
Loading ...
Loading ...
9
GAS CONNECTION - NATURAL GAS (NG)
NEVER CONNECT THE VERSAPOWER™ COOKING SYSTEM
TO AN UNREGULATED GAS SUPPLY.
Before proceeding, ensure the unit is fitted for natural gas. Connecting to an improper gas type will result
in poor performance and increased risk of damage or injury. The installation of this appliance must con-
form with local codes or, in the absence of local codes, to the national fuel gas code, ANSI Z223.1a-
1988. Installation in Canada must be in accordance with the Standard CAN/ CGA-B149.1 Natural Gas
Installation or CAN/CGA-B149.2, Propane Installation Code.
Manifold pressure with NG: Operating: 5.0” W.C.
Non-operating: 5.5” W.C.
Optimum pressure: 7.0” W.C.
NOTE: To ensure proper heating performance of this appliance, verify that the gas line supply pressure
is adequate (7.0” W.C. supply pressure is preferred) to maintain 5” W.C. manifold pressure.
Use a minimum 1/2” ID flex hose to prevent gas starvation.
NATURAL GAS CONNECTION:
Ensure that the service pipe supplying the VERSAPOWER™ Cooking System is fitted with a shut off
valve conveniently positioned and easily accessible as an emergency gas shutoff.
Your ALFRESCO™ VERSAPOWER™ Cooking System for use with Natural Gas comes equipped with
it‘s own regulator which MUST NOT be removed. If this regulator needs to be replaced use only the type
specified by ALFRESCO™ for this appliance.
To connect the regulator / hose assembly follow the next steps:
1. Locate the regulator and gas connection point in the rear
left side of your unit.
2. Attach a 1/2” FPT x 1/2” MPT (male-to-female) elbow to
the regulator (see figure # 3).
3. Fasten the hose connection to a 1/2” MPT x 3/8” COMP
(compression flare fitting) connected to the elbow.
(see figure # 3).
Connect flare fitting to gas supply using a 1/2” Ø minimum flexible stainless steel gas hose, no more
than 48” in length.
CAUTION
CYLINDERS MUST BE STORED OUTDOORS IN A WELL-VENTILATED AREA
OUT OF THE REACH OF CHILDREN.
DISCONNECTED LP CYLINDERS MUST HAVE THREADED VALVE PLUGS TIGHTLY
INSTALLED, AND MUST NOT BE STORED IN A BUILDING, GARAGE OR ANY OTHER
ENCLOSED AREA. THE GAS MUST BE TURNED OFF AT THE SUPPLY CYLINDER
WHEN THE UNIT IS NOT IN USE. IF THE APPLIANCE IS STORED INDOORS, THE
CYLINDER MUST BE DISCONNECTED AND REMOVED FROM THE APPLIANCE.
WARNING
ENSURE THAT THE GAS
SUPPLY HOSE DOES
NOT COME IN CONTACT
WITH THE GRILL BODY
Loading ...
Loading ...
Loading ...