Loading ...
Loading ...
Loading ...
Switching on the drive-ready state via
emergency detection of the remote
control
It is not possible to start the engine if the re‐
mote control has not been detected.
It is not possible to switch on the drive-ready
state if the remote control has not been de‐
tected.
Proceed as follows in this case:
1.
Hold the remote control as shown against
the marked area on the steering column.
Pay attention to the display in the instru‐
ment cluster.
2. If the remote control is detected:
Switch on drive-ready state within 10 sec‐
onds.
If the remote control is not detected, slightly
change the position of the remote control and
repeat the procedure.
Integrated key
General information
The driver's door can be locked and unlocked
without remote control using the integrated
key.
Safety information
WARNING
Unlocking from the inside is only possible
with special knowledge.
Persons who spend a lengthy time in the vehi‐
cle while being exposed to extreme tempera‐
tures are at risk of injury or death. Do not lock
the vehicle from the outside when there are
people in it.◀
NOTE
The door lock is permanently joined with
the door. The door handle can be moved.
When pulling the door handle with the
integrated key inserted, paint or the integrated
key can be damaged. There is a risk of damage
to property. Remove the integrated key before
pulling the outside door handle.◀
Removing
Press the button, arrow 1, and pull out the
integrated key, arrow 2.
Locking/unlocking via the door lock
1.
Remove lid on the door lock.
To do this, slide the integrated key into the
opening from below and remove the lid.
2. Unlock or lock the door lock using the
integrated key.
Seite 56
CONTROLS
Opening and closing
56
Online Edition for Part no. 01402983594 - X/17
Loading ...
Loading ...
Loading ...