Loading ...
Loading ...
Loading ...
Jump
Starting
If
your battery has run down, you may want to use
another vehicle and some jumper cables to start your
vehicle. Be sure to follow the steps below to do it safely.
I-
Ba..,ries can
hi.-
-
you.
’_
--?y cal. Je c-.lgerous
because:
They contain acid that can burn you.
They contain gas that can explode or
They contain enough electricity to
ignite.
burn you.
If
you don’t follow these steps exactly, some
or all of these things can hurt you.
Notice:
Ignoring these steps could result in costly
damage to your vehicle that wouldn’t be covered
by your warranty.
Trying to start your vehicle by pushing or pulling
it
won’t work, and
it
could damage your vehicle.
1.
Check the other vehicle. It must have a 12-volt
battery with a negative ground system.
Notice:
If the other system
isn’t
a 12-volt system
with a negative ground, both vehicles can be
damaged.
2. Get the vehicles close enough so the jumper cables
can reach, but be sure the vehicles aren’t touching
each other.
If
they are, it could cause
a
ground
connection you don’t want.
You
wouldn’t be able to
start your vehicle, and the bad grounding could
damage the electrical systems.
To avoid the possibility of the vehicles rolling, set
the parking brake firmly on both vehicles involved in
the jump start procedure. Put an automatic
transaxle in PARK (P) or a manual transaxle in
NEUTRAL before setting the parking brake.
Notice:
If
you leave your radio on,
it
could be badly
damaged. The repairs wouldn’t be covered by
your warranty.
3.
Turn off the ignition on both vehicles. Unplug
unnecessary accessories plugged into the cigarette
lighter. Turn
off
the radio and all lamps that aren’t
needed. This will avoid sparks and help save
both batteries. And it could save your radio!
4. Open the hoods and locate the batteries. Find the
positive
(+)
and negative
(-)
terminal locations on
each vehicle. See
Engine Compartment Overview
on page
5-12
for more information on location.
5-42
Loading ...
Loading ...
Loading ...