Loading ...
Loading ...
Loading ...
11
3. Cloud monitor base Firmware
• IP Address
The IP address of the device. If DHCP is disabled, you must set this field to a valid IP address. If
DHCP is enabled, you cannot edit this field.
• Subnet Mask
The subnet mask of the device. If DHCP is disabled, you must set this field to a valid subnet mask.
If DHCP is enabled, you cannot edit this field.
• Gateway
The gateway IP address of the device. If DHCP is disabled, this field is required. If DHCP is
enabled, you cannot edit this field.
• Primary DNS Server
The primary DNS IP address of the device. This field is optional. If the DNS server IP address is
configured using the Connection Manager, the address may be set as an FQDN instead of an IP
address.
• Secondary DNS Server
The secondary DNS IP address of the device. This field is optional. If the DNS server IP address
is configured using the Connection Manager, the address may be set as an FQDN instead of an IP
address.
• Domain Name
The domain name used (e.g., ‘domain.local’). This field is optional. This field specifies the host or
domain of the client.
• FQDN
The Fully Qualified Domain Name for the host or client. The default value is pcoip-host-<MAC>
or pcoipportal-<MAC> where <MAC> is the MAC address of the host or client. The domain
name is appended if used (e.g., pcoip-host-<MAC>.domain.local). This field is read-only on this
page.
• Ethernet Mode
Lets you configure the Ethernet mode of the host or client as:
• Auto
• 100 Mbps Full-Duplex
• 10 Mbps Full-Duplex
When you choose 10 Mbps Full Duplex or 100 Mbps Full Duplex and then click Apply, a
warning message will appear. “Warning: When Auto-Negotiation is disabled on the PCoIP
device, it must also be disabled on the switch. Additionally, the PCoIP device and switch must
be congured to use the same speed and duplex parameters. Different parameters may result
in a loss of network connectivity. Are you sure you want to continue?” Click OK to change the
parameter.
Note
You should always set the Ethernet Mode to Auto and only use 10 Mbps Full Duplex or 100Mbps Full
Duplex when the other network equipment (i.e., switch) is also congured to operate at 10 Mbps full-
duplex or 100 Mbps full-duplex. An improperly congured Ethernet Mode may result in the network
operating at half-duplex which is not supported by the PCoIP protocol. The session will be severely
degraded and eventually dropped.
Loading ...
Loading ...
Loading ...