Loading ...
Loading ...
Loading ...
6
RQT9655
Network settings
To use the AirPlay function, this unit must join the
same wireless network as the compatible device.
(> 4)
1 Press [Í/I] to turn the unit on.
≥ Only the power on indicator lights when the wireless
network is not set.
2 Check which type of wireless network
router you are using.
∫ “Method 1” :
If your wireless network router supports WPS
(Wi-Fi Protected Setup
TM
).
∫ “Method 2” :
If your wireless network router does not support
WPS (Wi-Fi Protected Setup
TM
).
≥ Refer to the operating instructions of the wireless
network router for details.
≥ When performing the network settings, place this unit
close to the wireless router.
≥ Simultaneous use with other 2.4 GHz devices, such as
microwaves, cordless telephones, etc., may result in
connection interruptions.
≥ Immediately after this unit is turned on, the network
setup may take longer to start.
≥ This unit cannot join a wireless network using WEP
security settings with
“Method 1”. Use “Method 2” to join
the wireless network.
≥ To cancel the setting in the middle, press [Í/I] to turn off
the unit.
≥ For up-to-date compatibility information on your Wireless
router refer to
http://panasonic.jp/support/global/cs/
(This site is in English only.)
∫ Using the WPS Push Button Configuration
(PBC)
1 Press and hold [– WPS] on the unit for
more than 2 seconds.
≥ Complete step 2 within 2 mins.
2 Press the WPS button on the wireless
router.
3 The unit’s settings are completed when
the Wi-Fi
®
status indicator stops blinking
after about 2 minutes and lights blue.
4 To use AirPlay, turn to page 9.
≥ To use the WPS PIN code, refer to the notes on page 8.
≥ To edit this system’s name, it is necessary to use
“Method 2”. (> 8, “Additional settings”)
If you do not know which type of wireless network
router you are using, use “Method 2”.
Lights red
Method 1
If your wireless network router supports WPS.
The WPS identifier mark.
WPS Push Button
Configuration (PBC)
compatible wireless router may
have this mark.
The Wi-Fi
®
status indicator turns off if the
connection was not made within the set time limit.
Try the setting again. If the Wi-Fi
®
status indicator
still turns off, try “Method 2”.
Blinks blue
SC-AP01PPC~RQT9655.book 6 ページ ２０１２年３月２日 金曜日 午後７時５７分
Loading ...
Loading ...
Loading ...