Loading ...
Loading ...
Loading ...
11
GAS ADJUSTMENT
NOTE: This appliance is fitted with a flame failure safety device on each burner which is
deigned to stop the flow of gas to the burner head in the event of a flame going out.
IMPORTANT: Take precautions when adjustments are carried out converting one gas to
another. All work must be carried out by a qualified technician.
Before starting any work, ensure that the gas and electricity supply to the appliance are
disconnected.
CHANGING THE INJECTOR
1. Remove the pan support, burner lid and flame spreader.
2. Unscrew the injector using a 7mm box spanner and
replace it with the stipulated injector for a new gas
supply.
3. Carefully reassemble all of the components.
4. After the injectors are replaced, it is advisable to strongly
tighten the injector in place.
ADJUSTING THE MINIMUM LEVEL OF THE FLAME
• Turn the taps down to minimum.
• Remove the knob from the tap and place a small
flat head screwdriver in the centre of the tap shaft.
• The correct adjustment has been reached when the
flame has a length of around 3 – 4 mm.
• For butane/ propane gas, the adjusting screw must
be tightly screwed in.
• Refit the control knob.
• Make sure that the flame does not go out by
quickly turning from maximum flow to minimum
flow. If it goes out, then remove the control knob
and make further adjustments to the gas flow,
testing it again once the adjustments have been
made.
ADJUSTMENT SCREWS
Control Dial
Gas Tap
Sealing Ring
Loading ...
Loading ...
Loading ...