Wet Sounds SYN-DX-4 Owner’s Manual

Loading ...

5 6 7 8

1. Fuses – The fuses protect the amplier against internal electrical damage and

are meant to protect the amplier only. All other power connections should be

fused at the source

2. (+) 12 Volt Power – Connect this terminal through a FUSE or CIRCUIT

BREAKER to the positive terminal of the vehicle battery or the positive terminal of

an isolated audio system battery.

3. Remote Turn On – This terminal turns on the amplier when (+) 12 volt is

applied to it. Connect it to the Remote Turn on lead of the head unit or signal

source.

4. Ground – Connect this terminal directly to the battery, using the shortest wire

necessary to make this connection. Always use wire of the same gauge or larger

than the (+) 12 volt power wire.

5. RCA Inputs - RCA Input Jacks—Accepts line level outputs from source units or

signal processors at voltages between 250mV and 6 volts.

6. Speaker Terminal Output Block 1-2 – This is the speaker connecting block for

channels 1 & 2.

7. Speaker Terminal Output Block 3-4 – This is the speaker connecting block for

channels 3 & 4.

8. Speaker Terminal Output Block 5-6 – This is the speaker connecting block for

channels 5 & 6.

AMP DIAGRAM WITH LEGEND

Wet Sounds SYN-DX Series Owner’s Manual

Loading ...

Wet Sounds SYN-DX-4 Series 4 Ch. Marine Amplifier