Wet Sounds SYN-DX-4 Owner’s Manual

Loading ...

SPEAKER TERMINAL INPUTS

The SYN-DX Series utilizes removable speaker terminal blocks for easier

installations and stronger power connections. The terminal blocks are designed to

accept 12 AWG- 16 AWG speaker wire. When preparing the wire you will need to

strip 5/8” of the cables protective shielding. Then take a small Phillips or at head

screwdriver and back out the screw on the terminal block. Insert the speaker wire

into the terminal block and then tighten the screw back into the terminal block. (DO

NOT OVERTIGHTEN) (See below)

Wet Sounds SYN-DX Series Owner’s Manual

POWER INDICATOR

The amplier is equipped with a dual illumination LED on the top of the amplier

that the Wet Sounds logo badge is mounted on. This amplier is equipped with an

advanced diagnostic system controlled by a microprocessor. In the event that the

unit goes into protection for any reason it will ash a diagnostic code. The different

sequences indicate the “Code” for faster trouble shooting. When the amplier rst

turns on the LED will ash blue. Once the amplier is ready for use the LED light

will change to solid blue. If the amplier is in protection mode (over voltage, under

voltage, DC offset, thermal heating or speaker short) the LED light will ash a red

diagnostic sequence. See troubleshooting section for further detail.

Loading ...

Wet Sounds SYN-DX-4 Series 4 Ch. Marine Amplifier