Wet Sounds SYN-DX-4 Owner’s Manual

Loading ...

TROUBLESHOOTING

1. Check your fuse and replace if necessary.

2. Conrm your Ground wire has a good connection.

3. Make sure your remote wire and power wire has +12 Volts.

4. Make sure your battery has 12 volts.

5. Conrm that the amplier LED color is blue. If the light ashing is red than the

amplier is in protection mode. If the light is red check the following items below:

A. See what sequence is ashing by referencing the chart below

B. Conrm that a/the speaker is not blown.

C. Conrm that there are no loose wires that could be grounding out the

amplier.

D. Check that the amplier has sufcient air circulation where it is

located. Insufcient air ow and overdriving the audio system could

result in the amplier going into protection to preserve the amplier.

If you are experiencing problems with your amplier after

installation follow these procedures to try and remedy the

problem.

Wet Sounds SYN-DX Series Owner’s Manual

or HTX 4, 6 ampliers, a short will only shut down the channels which are in fault. The other channels will

contiunue to play

. After a fault connec

tion is cleared, the error code will continue to ash, while the logo is

still illuminated blue. Please contact Tech Support for additional assistance, questions, etc.

Wet Sounds SYN-DX Fault Codes

Circuit Board

Loading ...

Wet Sounds SYN-DX-4 Series 4 Ch. Marine Amplifier