Loading ...
Loading ...
Loading ...
Using your dishwasher
Getting the most from your appliance
Before first use
Before using your appliance for the first time:
Set the water softener
Fill the rinse aid dispenser
Fill in detergent
Add 1.5Kg dishwasher salt and thenfull fill the salt
container with water
The dishwasher is designed with a softener to
eliminate the minerals and lime from the water
supply. The hardness of the water supply varies
from place to place and will affect the dishwasher
performance. The amount of salt consumed can
be adjusted based on the hardness of the water
used. This is intended to optimise and customize
the level of salt consumption.
Water Softener
1. Remove the lower basket and then unscrew and remove
the cap from the salt container. (Fig 1)
Loading the salt into softener
2. Place the end of the funnel(supplied) into the hole and
introduce about 1.5kg of dishwasher salt.
3. Full fill the salt container with water.It is normal for a small
amount of water to come out of the salt container. (Fig 2)
4. Screw the cap tightly back clockwise.
5. Immediately after filling the salt, a washing cycle should
be started (soak or rapid program suggested). Otherwise the
filter system or pump may be damaged by salty water.
Only use dishwasher salt.
Add the salt again when the salt warning light at control
panel is on.
It takes time to dissolve the salt so the salt warning
light may still come on even the salt container is filled.
Important:
0345 257 7271.
22
Using your
dishwasher
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in
the amount of salt consumed based on the hardness
of the water used. This is intended to optimise and
customise the level o f salt consumption.
Please follow the steps below for adjustment in salt
consumption.
1. Switch on the appliance;
2. Press the Start/Pause button for more than 5
seconds to start the water
softener set model within 60seconds after the
appliance was
switched on;
3. Press the Start/Pause button to select the proper
set according to
your local environment, the sets will change in the
following sequence: H1->H2->H3->H4->H5->H6;
4. Press the button to end the set up model.Power
WATER HARDNESS
Selector Position
Salt c onsumption
(gram/cycle)
H1
H2
H3
H4
H5
H6
0
9
12
20
30
60
dH
0~5
6-11
12-17
18-22
23-34
35-55
0~9
10-20
21-30
fH
31-40
41-60
61-98
0~6
7-14
15-21
Clarke
22-28
29-42
43-69
mmol/l
0~0.94
1.0-2.0
2.1-3.0
3.1-4.0
4.1-6.0
6.1-9.8
1
Open
2
Loading ...
Loading ...
Loading ...