Loading ...
Loading ...
Loading ...
30
INSTALLATION INSTRUCTIONS
Electrical Requirements
CAUTION: FOR PERSONAL SAFETY,
REMOVE HOUSE FUSE OR CIRCUIT
BREAKER BEFORE BEGINNING
INSTALLATION.
This appliance must be supplied with the
proper voltage and frequency, as listed in these
Installation Instructions, and connected to an
individual, properly grounded branch circuit,
protected by a circuit breaker or time delay fuse.
Proper electrical ratings
should be verified with
listing on product’s rating
plate. The rating plate is
located on the right-hand
side of the exhaust plenum.
All wire connections must be made in accordance
with local codes and properly insulated. Check
with your local utility for governing electrical
codes and ordinances. In the absence of local
electrical codes, the National Electrical Code,
ANSI/NFPA No. 70–Latest Edition, governing
electric range installations, must be followed.
A copy of the National Electrical Code can be
obtained by writing to:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02260
Before you begin
Read these instructions completely and
carefully.
Important—Save these instructions for
local inspector’s use.
Important—Observe all governing codes
and ordinances.
NOTE TO INSTALLER—Be sure to leave
these instructions with the Consumer.
NOTE: This appliance must be properly
grounded.
Unless very knowledgeable in the installation
of this product, engage a professional installer.
Tools You Will Need
• Saw
• Flat blade screwdriver
• Electrician’s pliers
• Duct tape
• Measuring tape or scale
• Carpenter’s square
• Wrench or socket set
• Drill and drill bit
• Sheet metal screws
• Junction box
NOTE: Installation of this unit requires 2 people.
Do not attempt to install without assistance.
30″ Cooktop (Dimensions for reference only) Unit must be vented to the outside!
21
9
⁄16″
20
1
⁄2″
21
3
⁄8″
3″
29
7
⁄8″
12
1
⁄4″
6″
27
1
⁄2″
28
7
⁄8″
NOTE: Electrical installation kit JXCK89
may be ordered separately and includes
all the parts necessary to connect the
cooktop to typical rough-in wiring.
10″
Rating
plate
Loading ...
Loading ...
Loading ...