Loading ...
Loading ...
Loading ...
CARE AND CLEANING
(continued)
Coil Surface Unit Module
Clean the area surrounding the surface units
according to either the Brushed Chrome or Porcelain
section (depending on your model).
To clean the surface units, turn the control to the
highest setting for a minute. The coils will burn off
any soil.
CAUTION
• Be sure all controls are turned to OFF and
surface units are cool before attempting to
remove them.
• Do not immerse the surface units or the module
in liquids of any kind.
• Do not clean the surface units or the module in
a dishwasher.
• Do not bend the surface unit plug terminals.
• Do not attempt to clean, adjust or in any way repair
the plug-in receptacle.
To remove a surface unit:
To remove the drip pans
for cleaning, the surface
units must be removed
first.
Lift the surface unit about
1 inch above the drip pan
and pull it out.
Do not lift the surface
unit more than 1 inch.
If you do, it may not lie
flat on the drip pan when
you plug it back in.
Repeated lifting of the surface unit more than
1 inch above the drip pan can permanently
damage the receptacle.
To replace a surface unit:
• Replace the drip pan into the recess in the cooktop.
Make sure the opening in the pan lines up with the
receptacle.
• Insert the terminals of the surface unit through the
opening in the drip pan and into the receptacle.
• Guide the surface unit into place so it rests evenly.
Drip Pans
Remove the surface units. Then lift out the drip pans.
For best results, clean the drip pans by hand.
Place them in a covered container (or a plastic bag)
with 1/4 cup ammonia to loosen the soil. Then scrub
with a soap-filled scouring pad if necessary. Rinse
with clean water and polish with a clean, soft cloth.
The drip pans may also be cleaned in the dishwasher.
Do not cover the drip pans with foil.
Using foil so close to the receptacle could cause
shock, fire or damage to the cooktop.
Clean the area under the drip pans often.
Built-up soil, especially grease, may catch on fire.
2828
Surface Unit
Drip Pan
Cleaning the Radiant Module
Normal Daily Use Cleaning
ONLY use the recommended cleaning
cream, Cerama Bryte
®
, on the glass
surface. Other creams may not be
as effective.
To maintain and protect the surface of
your radiant module, follow these steps:
1. Before using the radiant module
for the first time, clean it with the
cooktop cleaning cream. This helps
protect the top and makes clean-up
easier.
2. Daily use of the cooktop cleaning cream will help
keep the glass surface looking new.
3. Shake the cleaning cream well. Apply a few drops of
the cream directly to the glass surface.
4. Use a paper towel or sponge to clean the entire
surface.
NOTE: It is very important that you DO NOT
heat the radiant module until it has been cleaned
thoroughly.
Clean your
radiant module
after each spill.
Loading ...
Loading ...
Loading ...