Loading ...
Loading ...
Loading ...
www.SereneLifeHome.com
4
INSTALLATION
The submersible pump is installed as follows:
• In a stationary position with xed pipeline.
• In a stationary position with a exible hose pipe.
Please note!
You should never install the pump by suspending it unsupported from its delivery
pipe or power cable. The submersible pump must be suspended from the specially
provided handle or be placed on the bottom of the shaft. To guarantee that the
pump works properly, the bottom of the shaft must be kept free of sludge and dirt
of all kinds. If the level of water sinks too far, any sludge in the shaft will dry out
quickly and stop the pump from starting up. Therefore it is necessary to check the
submersible motor pump regularly (by carrying out start-up tests). The oater is
adjusted in a way that the pump can immediately be started.
Note!
The pump shaft should have minimum dimensions of 40 x 40 x 50 cm, so that the
oating switch can move freely.
MAINS SUPPLY
Your new submersible pump is equipped with a shock-proof plug according to
regulations. The pump is designed to be connected to a 220V - 50Hz earthed socket.
Make sure that the socket is suciently secured (min.6 Amp.) and is in excellent
condition. Introduce the plug into the socket and the pump is ready to go.
Important Note!
If the mains cable or plug suers any damage from external action, repairs to the
cable should be serviced by a qualied specialist using only standard spare parts.
This will ensure that it meets the required safety standards.
SETTING TO WORK
After having read these instructions carefully, you can set your pump to work,
reconsidering the following item:
• Check if the pump rests on the ground of the shaft.
• Check if pressure cord has been attached properly.
• Check if electrical connection is 110V 60Hz
• Check if the socket is in good condition.
• Make sure that water and humidity can never come to the mains supply.
• Avoid pump running dry.
Loading ...
Loading ...
Loading ...