Loading ...
Loading ...
Loading ...
12
Replacing the Scraper Bar
1. The scraper bar is located at the base of the snow thrower
beneath the rotor housing (Fig. 21).
2. Remove the 3 screws that secure the scraper bar to the
snow thrower (Fig. 22). Remove the old scraper bar.
3. Install the new scraper bar and fasten it securely to the
snow thrower with the 3 screws.
Replacing the Belt
NOTE: Under normal operating conditions it should not be
necessary to replace the auger belt. However, should the auger
jam or malfunction, the belt could be damaged. To replace the
belt follow the instructions.
NOTE: Determine the left and right hand side of the
snow thrower by standing behind the unit in the normal
operating position.
1. Open the left side plate by removing the seven screws
(Fig. 23).
2. Use your right hand to turn the rib side of the belt
up and pull upwards while turning the auger pulley
counterclockwise with your left hand. The belt can be
easily removed from the pulley (Fig. 24).
3. Put the belt on the drive pulley rst and then place the
belt at the lower end of the auger pulley (Fig. 25).
Fig. 21
Scraper
bar
Fig. 22
The screws that secure the scraper bar
Fig. 23
Remove the
7 screws
Fig. 24
Auger pulley
Fig. 25
Auger pulley
Drive pulley
Loading ...
Loading ...
Loading ...