Loading ...
Loading ...
Loading ...
8. Use the arrow buttons to select the % of the
cutting time the product must cut the area.
The % is equal to the % of the area in
relation to the complete work area.
a) Measure the area.
b) Divide the area with the work area.
c) Convert the result to %.
30%
20%
9. Push the BACK button.
3.9.4.2 To do a test of the Lawn Coverage
function
1. Put the product in the charging station.
2. Do step 1-3 in
To get access to the menu on
page 21
.
3. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Lawn Coverage > Area 1-3 > More > Test
.
4. Push the OK button.
5. Push the START button.
6. Close the hatch.
7. Make sure the product can find the area.
3.9.4.3 To measure the distance from the
charging station
1. Put the product in the charging station.
2. Do steps 1–3 in
To get access to the menu
on page 21
.
3. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Lawn Coverage > Area 1-3 > How far?
4. Use the arrow buttons to set 500 m as a
distance.
5. Push the OK button.
6. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Lawn Coverage > Area 1-3 > More > Test
.
7. Push the OK button.
8. Push the STOP button when the product is
at the distance you select to measure. The
distance shows in the display.
3.9.4.4 To disable or enable the Lawn Coverage
function
Disable or enable the
Lawn Coverage
function for
each area.
1. Do steps 1–3 in
To get access to the menu
on page 21
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Lawn Coverage > Area 1-3 > Disable
.
3. Push the OK button.
4. Push the BACK button.
3.9.4.5 To reset the Lawn Coverage settings
You can reset the
Lawn Coverage
settings for
each area and use the factory setting.
1. Do steps 1–3 in
To get access to the menu
on page 21
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
Lawn Coverage > Area 1-3 > More > Reset
.
3. Push the OK button.
3.9.5 To set the starting point
This function allows you to control how far the
product drives along the guide wire from the
charging station before it starts operating. The
factory setting is 60 cm and the maximum
distance is 300 cm.
Note: This is a useful function if the charging
station is placed below a veranda or in another
limited space area. If the charging station is
placed in an open area, the factory setting can be
used. Choosing a good starting point is important
so that the guide calibration process is optimized.
1. Do steps 1-3 in
To get access to the menu
on page 21
.
2. Use the arrow button and the OK button to
move through the menu structure
Settings >
Installation > Starting point
.
24 - Installation 982 - 003 -
Loading ...
Loading ...
Loading ...