Loading ...
Loading ...
Loading ...
21
Data Port Connection between the MA252 and a
McIntosh Source Component allow for basic function
control of the source component using the MA252
Remote Control. By default, the Data Port setting of
“All Data” sends the received IR Data to the DATA
PORT Output Jack. To dedicate the Data Port for only
one MA252 source component perform the following
Steps:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 19.
2. Rotate the INPUT Control until “SETUP: Data
Ports, All DATA” appears on the Information Dis-
play. Refer to figure 20.
3. Rotate the VOLUME (ADJUST) Control to select
the desired MA252 Input. Refer to figure 21.
4. Exit the SETUP Mode by several presses of the
INPUT Control.
19. Rotate the INPUT Control until the “_” empty
space to the right of character P is flashing, then
rotate the VOLUME (ADJUST) Control to change
the “_” empty space to character to “L”. Refer to
figure 14.
20. Repeat step 19 until the new name of “ RENAME:
BAL, CD PLAYER” is indicated on the Front
Panel Display. Refer to figures 15 thru 18.
21. To save the new name, press and hold in the IN-
PUT Control until “SETUP: CD PLAYER , ON /
Rename” appears on the Front Panel Information
Display. Refer to figure 19.
Setup, con’t
Figure 14
RENAME: BAL
>CD PL
Figure 19
SETUP: CD PLAYER
On/Name(Hold IN)
Figure 16
RENAME: BAL
>CD PLAY
Fig u re 17
RENAME: BAL
>CD PLAYE
Figure 15
RENAME: BAL
>CD PLA
Data Port
Figure 20
SETUP: Data Port
All Data
Figure 21
SETUP: Data Port
Bal
Figure 18
RENAME: BAL
>CD PLAYER
22. Exit the SETUP Mode by several presses of the
INPUT Control.
Remote Control Codes
The HR091 Remote Control included with the MA252
utilizes the NORMAL McIntosh Control Codes. The
Second Set of Control Codes the MA252 will respond
to is referred to as the ALTERNATE Codes. The Al-
ternate Codes are used when the MA252 is used in the
same location as another McIntosh Preamplifier and/or
A/V Processor. This will prevent the Remote Control
from affecting the operation of both units at the same
time. To activate the Remote Control ALTERNATE
Codes perform the following steps:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 19.
2. Rotate the INPUT Control until “SETUP: IR
Codes, Normal” appears on the Information
Display. Refer to figure 22.
3. Rotate the VOLUME (ADJUST) Control to the
Alternate Codes. Refer to figure 23.
4. Exit the SETUP Mode by several presses of the
INPUT Control.
Figure 22
SETUP: IR Codes
Normal
Figure 23
SETUP: IR Codes
Alternate
Loading ...
Loading ...
Loading ...