Loading ...
Loading ...
Loading ...
78
En
Useful Remote Control Features
13
Useful Remote Control Features
Learning function of the remote control
unit
You can operate the connected AV products (AV Receiver,
Cable Box, SAT tuner, VCR, DVD, DVD recorder, LD) using the
learning function of your remote control unit. This remote
control unit has a function that can memorize each remote
control code.
Using the learning function
1 Slide the Mode switch to match the device whose remote
control signal you want to be learned.
2 Press EDIT/LEARN and 2 at the same time.
• The LED flashes.
3 Press a button to be learned.
• The LED lights up.
• For the functions that can be learned, see pages 80 to
84.
• When learning is finished, the LED starts flashing again.
4 Press EDIT/LEARN again to exit the Learn mode.
NOTE
• To exit the Learn mode before it is complete, press EDIT/
LEARN again.
•If the Mode switch selection is changed when in the Learn
mode, the Learn mode is canceled.
• If no operation is performed for more than one minute, the
Learn mode is canceled.
• It takes about 2 seconds to finish code transmission. Do not
interrupt it halfway. Wait until the LED flashes again.
• You can reset all learned codes to the factory defaults. When
not in the Learn mode, press and hold TV , and then press
FAVORITE A (blue) and FAVORITE D (yellow) at the same
time.
Presetting manufacturer codes
1 Slide the Mode switch to match the device to which you
want to preset the remote control signal.
2 Press EDIT/LEARN and 1 at the same time.
• The LED flashes.
3 Press 0 – 9 to enter the manufacturer code. See page 79.
• Preset mode is finished once the LED no longer lights
up.
NOTE
• To exit the Edit mode before it is complete, press EDIT/
LEARN again.
•If the Mode switch selection is changed when in the Edit
mode, the Edit mode is canceled.
• If no operation is performed for more than one minute, the
Edit mode is canceled.
• When you enter a code not listed, the LED flashes quickly.
• If the table on page 79 does not include your device’s
manufacturer or the remote control does not work, you can
make the memory learn its signal by the Learn mode.
• The initial mode is “000” (PIONEER).
2 to 5 cm (0.8 to 2.0 inches)
Remote control
(Supplied accessory)
Remote control of
AV product
Loading ...
Loading ...
Loading ...