Loading ...
Loading ...
Loading ...
8
Operator Specifications
Usage Classification
Class I, II, III, & IV
Main AC Supply 120 Vac, 4 Amps (10 Amps including Accessory Outlets) OR 240 Vac, 2 Amps
When Optional Transformer Kit Model 3PHCONV is installed in the field, operator is rated
208/240/480/575 VAC, 5.2/4.5/2.3/1.9 A, 60 Hz, 1 PH
System Operating Voltage
24 Vdc Transformer Run / Battery Backup
Accessory Power
24 Vdc, 1A max. for ON + SW (switched)
Solar Power Max
24 Vdc at 60 watts max.
Maximum Gate Weight/Length
14 ft. - 2,800 lbs.
16 ft. - 2,400 lbs.
18 ft. - 2,200 lbs.
20 ft. - 1,800 lbs.
22 ft. - 1,500 lbs.
To optimize performance and extend operator life, the long arm kit model HDLGARM is
recommended when installing with gates 16ft. or longer. See Accessories page 53.
When HDLGARM is used, operator has the following maximum gate weight/length:
14 ft. - 4,500 lbs.
16 ft. - 3,750 lbs.
18 ft. - 3,250 lbs.
20 ft. - 2,750 lbs.
22 ft. - 2,500 lbs.
90 Degree Travel Time 13-36 seconds NOTE: Travel time will vary based on arm configuration and speed controlsettings.
Maximum Travel Range 115 degrees NOTE: Travel range will very based on arm configuration.
Maximum Daily Cycle Rate
Continuous
Maximum Duty Cycle
Continuous
Operating Temperature
Without Heater: -20°C to 60°C (-4°F to 140°F)
With Optional Heater: -40°C to 60°C (-40°F to 140°F)
External Entrapment Protection Device Inputs
(non-contact and/or contact)
Main board - up to 2 close entrapment protection devices and 1 open entrapment protection device.
Expansion board - up to 3 entrapment protection devices configurable to either the close or open
direction and up to 8 edge sensors when using the wireless edge sensor kit model LMWEKITU and
LMWETXU.
27.85" (70.7 cm)
14.82" (37.6 cm)
16.77" (42.6 cm)
1.31" (3.3 cm)
14" (35.6 cm)
12.2" (31 cm)
INTRODUCTION
Loading ...
Loading ...
Loading ...