Loading ...
Loading ...
Loading ...
14
Using the clock and timer.
To Set the Clock
The clock must be set to the correct time of
day for the automatic oven timing functions
to work properly. The time of day cannot
be changed during a timed baking or self-
cleaning cycle. You cannot change the
clock time while an automatic oven
function is programmed.
Touch and hold the TIMER/CLOCK pad.
Touch the + and – pads.
Touch the START pad.
To check the time of day when the display is
showing other information, simply touch the
TIMER/CLOCK pad. The time of day shows
until another pad is touched.
Make sure the clock is set to the
correct time of day.
To Set the Timer
Touch the TIMER/CLOCK pad.
Touch the + and – pads until the
amount of time you want shows
in the display. Maximum time that can
be entered in minutes is 59. Cooking
times more than 59 minutes should be
changed to hours and minutes. For
example, enter 90 minutes as 1 hour,
30 minutes.
If you make a mistake, touch the
TIMER/CLOCK pad and begin again.
Touch the START pad.
When the timer reaches :00,the
control will beep 3 times followed
by one beep every 6 seconds until
the TIMER/CLOCK pad is touched.
The 6 second tone can be canceled by following the
steps in the Special features of your oven control
section under Tones at the End of a Timed Cycle.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by touching
the TIMER/CLOCK pad, then touch the + and
– pads until the time you want appears in
the display.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching the TIMER/CLOCK pad and then
touching the + and – pads until the time
you want appears in the display.
Power Outage
If a flashing time is in the display, you have
experienced a power failure. Reset the clock.
To reset the clock, touch and hold the
TIMER/CLOCK pad until the display changes.
Enter the correct time of day by touching
the + and – pads until the time you want
appears in the display. Touch the START pad.
To Cancel the Timer
Touch the TIMER/CLOCK pad twice.
Operating Instructions Safety InstructionsCare and CleaningInstallation Instructions
Troubleshooting Tips
Loading ...
Loading ...
Loading ...