User Manual Kwikset 99090-019 Deadbolt, Venetian Bronze

• Owner's manual - (English)

• Specification Sheet - (English)
• Warranty - (English)

Deadbolt User Manual Kwikset model 99090-019

Table Of Contents

• Mastercode
• Troubleshooting: Door Jamming and Door Handing
• Troubleshooting: Keypad
• Troubleshooting: Battery
• Battery FAQ

Adding User Codes with the Mastercode Enabled

• The procedure for adding user codes is different when the Mastercode is enabled. For instuctions on how to add user codes when the Mastercode is disabled, see the Installation and User Guide that came with your lock.
• Keep door open. Press the Program button once. The keypad will fl ash green and you will hear three beeps.
• Enter Mastercode.
• Press Lock button once.
• Press the Program button the number of times that corresponds to the user code position being programmed.
• Example: If programming the third code, press the button three times.
• Enter new user code.
• Press Lock button once.
• The procedure for adding user codes is different when the Mastercode is enabled. For instuctions on how to add user codes when the Mastercode is disabled, see the Installation and User Guide that came with your lock.
• If programming is successful, the keypad will flash green once with one beep.
• If programming is unsuccessful, the keypad will fl ash red three times with three beeps. Make sure the user code is not a duplicate and that it is between 4 and 8 digits during your next attempt. Make sure to enter a valid Mastercode in step 2.
• While the door is open and locked, test the user code to make sure it unlocks the door.

Disabling and Deleting the Mastercode

• Keep door open. Press and HOLD the Program button until the keypad fl ashes green (about 5 seconds).
• Press Lock button once.
• Enter Mastercode.
• Press Lock button once.
• Re-enter Mastercode.
• Press Lock button once.

If programming is successful, the keypad will flash green once with one beep.

If programming is unsuccessful, the keypad will fl ash red three times with three beeps. Make sure the Mastercode has been enabled before trying to disable it. Attempt the procedure again, making sure to enter the same Mastercode in steps 3 and 5.

Make sure switch #3 is on, and press the Program button once. If you don’t immediately hear three beeps and see the keypad fl ash green three times, the Mastercode is disabled.

Note: The lock will time out after fi ve seconds.