Loading ...
Loading ...
Loading ...
Help with the appliance en
67
3 Help with the appliance
Help with the appliance
Faults Cause/Remedy
Appliance does not start. Check the mains plug and the fuses.
The appliance does not
respond to inputs and the dis-
play shows: Please clean lint
filter
■ If there is fluff or debris in the fluff filter or if the fluff filter is damp,
this may impair the airflow in the appliance at low ambient tempera-
tures.
– Clean the base unit and dry the fluff filter thoroughly.
~ Page 57
– Switch the appliance off and on again.
– Press A Start/Reload to restart the programme.
Creasing. ■ Load exceeded or incorrect programme selected for a type of fabric.
All the required information can be found in the programme
table.~ Page 27
■ Remove laundry from the drum as soon as the drying programme
has finished. Creasing occurs when clothing is left in the drum.
Water is leaking out. ■ The appliance may be positioned at an angle. Level the appliance.
■ In the base unit, make sure that:
– The heat exchanger cover is properly locked.
– There is no dirt or debris on the heat exchanger cover's seal.
~ Page 57
■ If the optional drain hose* is installed, make sure that the drain hose
is correctly connected. ~ Page 54
The appliance is paused but the
drum is turning.
The appliance has detected a high temperature and has started the
CoolDown process. Temperature regulation can take up to 10 minutes.
You can cancel the CoolDown process at any time by opening the door.
The programme does not start Make sure that:
■ The door is closed
■ The Child Lock push 3 sec. has been deactivated
■ You have pressed A Start/Reload
Note: If the programme has been delayed by setting Finished in , the
programme starts at a later point.
Programme duration displayed
changes as drying progresses.
Not a fault. The moisture sensor measures the residual moisture in the
laundry and adjusts the programme duration (with the exception of timed
programmes).
Loading ...
Loading ...
Loading ...