Loading ...
Loading ...
ENG - 3
WIRING THE MAIN POWER
SUPPLY PLUG (UK ONLY)
IMPORTANT NOTICE
The mains lead on this equipment is supplied with a moulded plug
incorporating a fuse. The value of the fuse is indicated on the pin face
of the plug and if it requires replacing, a fuse approved to BS1362 of
the same rating must be used.
Never use the plug with the fuse cover removed. If the cover is
detachable and a replacement is required, it must be of the same
colour as the fuse tted in the plug. Replacement covers are available
from your dealer. If the tted plug is not suitable for the power
points in your house or the cable is not long enough to reach a power
point, you should obtain a suitable safety approved extension lead or
consult your dealer for assistance.
However, if there is no alternative to cutting off the plug, remove the
fuse and then safely dispose of the plug. Do not connect the plug to a
mains socket as there is a risk of shock hazard from the bared exible
cord. Never attempt to insert bare wires directly into a mains socket.
A plug and fuse must be used at all times.
IMPORTANT
The wires in the mains lead are coloured in accordance with the
following code:– BLUE = NEUTRAL BROWN = LIVE As these colours
may not correspond to the coloured markings identifying the
terminals in your plug, proceed as follows:– The wire coloured
BLUE must be connected to the terminal marked with the letter
N or coloured BLUE or BLACK. The wire coloured BROWN must be
connected to the terminal marked with the letter L or coloured
BROWN or RED.
WARNING : DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL
WHICH IS MARKED WITH THE LETTER E OR BY THE EARTH SYMBOL
, OR COLOURED GREEN OR GREEN AND YELLOW.
PRECAUTIONS
1. Ensure that the AC power supply in your house complies with the
power requirements listed on the identication sticker located
on the bottom of your product. Install your product horizontally,
on a suitable base (furniture), with enough space around it for
ventilation (7~10 cm). Make sure the ventilation slots are not
covered. Do not place the unit on ampliers or other equipment
which may become hot. This unit is designed for continuous use.
To fully turn off the unit, disconnect the AC plug from the wall
outlet. Unplug the unit if you intend to leave it unused for a long
period of time.
2. During thunderstorms, disconnect the AC plug from the wall
outlet. Voltage peaks due to lightning could damage the unit.
3. Do not expose the unit to direct sunlight or other heat sources.
This could lead to overheating and cause the unit to malfunction.
4. Protect the product from moisture (i.e. vases), and excess heat
(e.g. a replace) or equipment creating strong magnetic or electric
elds. Unplug the power cable from the AC wall socket if the unit
malfunctions. Your product is not intended for industrial use. It is
for personal use only. Condensation may occur if your product has
been stored in cold temperatures. If transporting the unit during
the winter, wait approximately 2 hours until the unit has reached
room temperature before using.
5. The battery used with this product contains chemicals that are
harmful to the environment. Do not dispose of the battery in the
general household trash. Do not expose the battery to excess
heat, direct sunlight, or re. Do not short circuit, disassemble, or
overheat the battery.
CAUTION : Danger of explosion if the battery is replaced
incorrectly. Replace only with the same or equivalent type.
Fabric cleaning
Remove any dirt or stain on the product surface immediately.
Removing and cleaning can be less effective for some substances or if
left for a prolonged time.
CAUTION
Use a vacuum cleaner or an adhesive lint roller to remove dust,
handprints, and the likes.
Some cleaning brushes may damage the product, depending on
the materials they contain.
Towels and cleaning clothes may leave lint or dirt on the
product.
Do not use a nail or other tools to scratch the dirt off. It may
damage the fabric.
To remove oil or liquid stains, use a clean white cloth moist with
water. If the stain persists, wipe it with a mixture of water and
neutral detergent (such as dishwashing soaps) and a cloth.
A non-neutral detergent or cleaner may cause discoloration or
fabric damage.
After cleaning, use a dry cloth or hairdryer to dry the area.
Do not use excessive force to avoid discoloration or fabric
damage.
Loading ...
Loading ...
Loading ...