Loading ...
Loading ...
Loading ...
25
CLEANING THE DUST BIN
1. Open the dust bin compartment cover by pressing
the PUSH button on the Robot Cleaner.
2. Grab the handle of the dust bin and pull it upward.
3. Pull the hook on the left of Filter Cover on the rear of
Dust Bin to separate the lter and the sponge.
※
Note that separating the lter may result in dust dropping.
※
Refer to p.26 when cleaning the Dust Bin Filter.
4. Lift the dust bin lid upward while pressing the separation
button on the dust bin.
5. Empty the dust bin and clean it with a cleaning brush
or under running water.
6. After cleaning with water, completely dry the dust bin in a
well-ventilated area out of the direct sunlight.
7. When reassembling or tting the cleaned Dust Bin,
close the lid and put in the Sponge and HEPA Filter.
※
Refer to p.26 for detailed assembly guides.
8. Put the dust bin into the Robot Cleaner and close the dust
bin compartment cover.
If the dust bin is full, suction power can be reduced. Clean the dust bin before or after each cleaning session.
Clean the dust bin using the following sequence:
• Operating the unit without Filters fitted to the dust bin can cause a motor malfunction not covered by warranty.
• After cleaning the Dust Bin, make sure to assemble the filter and fit it to the Dust Bin.
If you initiate cleaning, with no filters fitted to the dust bin or Filter Cover not assembled,
a voice message will be announced which says "Please check that the dust bin and filter are properly installed."
• Always ensure that the dust bin lid is refitted correctly after cleaning the dust bin so that it closes easily and
accurately.
Tip
Loading ...
Loading ...
Loading ...