We recommend that you use a professional
electrician to install the USB charging wall outlet.
For information about electrical specications, see
SPECIFICATIONS.
SAFETY
Warnings:
• RISK OF ELECTRIC SHOCK — Use only in dry
locations and only indoors.
• All cables should be routed away from the
charger outlet openings.
• DO NOT use with any aquarium equipment.
• DO NOT install in a wall box that is not grounded.
Notes to the installer:
• This device must be installed in accordance with
National and Local electrical codes.
• To prevent severe shock or electrocution, always
turn power OFF at the service panel before
working with wiring.
• This device should ONLY be used with copper or
copper-clad wire. DO NOT use with aluminum wire.
• DO NOT install this device into a shallow wall
box. The wall box must be deep enough to house
the charger outlet. If the box is too shallow, the
charger outlet will not t securely into the wall.
• This device is to be installed in a wall box
measuring at least 3.9 × 2.4 × 2.0 in.
(99 × 59.9 × 50 mm).
• Use at least 12 or 14 AWG stranded/solid copper
wire.
• Neither this device, nor its outlets or ports, is
intended to support permanently connected
equipment.
• Use USB connectors with interconnecting cables.
PACKAGE CONTENTS
• 4.8A USB Charging Wall Outlet
• White decora-style wall plate
• Screws (two long and two short)
• Quick Setup Guide
FEATURES
• Replaces a standard duplex outlet
• Quickly charges USB devices
• Tamper-resistant outlets for added safety
• Provides two USB ports with 4.8A total output
• Light sensor turns nightlight on and o
automatically
• Three nightlight settings: High/Low/OFF
• Works in nearly all installations
• Compatible with your existing decora wall plate
Before using your new product, please read these instructions to prevent any damage.
INSTALLING THE WALL OUTLET
1 Warning: DISCONNECT POWER. Failure to
do so can result in severe injury or death.
Make sure that you disconnect power to the
circuit by removing the fuse from the fuse
box or by turning o the circuit breaker.
2 Remove the wall plate that covers the old
outlet, then remove the mounting screws.
3 Carefully remove the existing outlet from the
wall box.
4 Disconnect the wiring from the old outlet.
5 Connect the wires to the charger outlet as
follows:
• Black lead attaches to the hot wire(s)
• White lead attaches to the neutral wire(s)
• Green lead attaches to the ground wire(s)
You can attach the wires by:
• Inserting straight wires into the holes.
• Wrapping the wires 3/4 of the way around
the terminal screws, making sure that the
wires do not overlap. Then tighten every
screw and make sure that no bare copper
wire is exposed. When tightening screws,
use 14-inch pounds of torque.
6 Carefully insert the charger outlet into the wall
box.
QUICK SETUP GUIDE
Nightlight and
USB Charging
Wall Outlet
NSHW48NL19
Nightlight
brightness
control
AC outlets
USB ports
Nightlight
sensor
LED nightlight
Hot (black)
Neutral
(white)
Ground
(green)
Loading ...
