Loading ...
Loading ...
Loading ...
Cleaning Cycle
The CLEAN LIGHT will illuminate blue to
indicate a Cleaning Cycle is required.
The Cleaning Cycle takes approximately
7 minutes to complete.
• Preparing for Cleaning Cycle
- Ensure there is at least 1 Litre of water
in the Reservoir.
- Empty the Drip Tray & replace.
-
The machine is on and in the READY state.
- Place the Two Cup Filter Basket & the
Cleaning Disc into the Group Handle.
- Place one Sunbeam Cleaning Tablet in
the middle of the Cleaning Disc in the
space provided.
- Insert Group Handle into the
Group Head.
• Start the Cleaning Cycle
- Simultaneously press & hold the
ON/OFF & MANUAL SHOT BUTTONS
for 4 seconds. The machine will beep and
the Cleaning Cycle will start.
- The ON/OFF & CLEAN LIGHTS will flash
during the cleaning cycle.
- Water will purge into the Drip Tray and
small amounts of water will pour from the
Group Handle spouts.
• Cleaning Cycle Complete
- The machine will beep and the ON/OFF &
CLEAN LIGHTS will stop flashing.
-
The machine will return to the READY state.
- Remove the Group Handle from the Group
Head. Check tablet has been dissolved.
• Cleaning Cycle Clean Up
-
Purge the Group Head by pressing the
ONE CUP BUTTON and water should flow.
- Allow water to run through until it stops.
- Wash the Drip Tray, Group Handle &
Cleaning Disc in warm water with a mild
detergent, rinse & dry.
Group Head Silicone Seal
A Silicone Seal is located in the Group Head
and creates a seal against the Filter Basket
when making an espresso.
Over time this Seal loses its elasticity and
may require replacement. The seal may
need replacing when watery espresso leaks
from around the Group Handle during
extraction, or if the Group Handle is loose
when fully turned to the centre position.
25
Care & Cleaning - Espresso Machine
Important:
When not being used, we
recommend not to leave the Group Handle
inserted into the Group Head, as this will
reduce the life of the Silicone Seal.
Note: Contact Sunbeam should you think
that the Group Head Seal needs replacing.
Do not attempt to change the Silicone Seal
without first consulting Sunbeam.
MAX
2.8 L
1 L
MIN
MANUAL SHOT
PRESS & HOLD TOGETHER 4 SEC
ON /OFF
ON /O
AL SH
Note: The Cleaning Cycle can be exited at
any point by pressing the ON/OFF BUTTON.
Note: If the tablet has not been dissolved,
insert the Group Handle back into the Group
Head, empty the Drip Tray & replace.
Repeat the 'Start the Cleaning Cycle' section.
MANUAL SHOT
GRINDER
ON / OFF
READY
D
I
S
C
F
O
R
C
L
E
A
N
I
N
G
T
A
B
L
E
T
U
S
E
T
H
I
S
S
I
D
E
U
P
ESPRESSO
MACHINE
CLEANING
TABLETS
Loading ...
Loading ...
Loading ...